FLOPLAST 50mm x 32mm Grey Pushfit Waste Pipe Reducer

Product Information

This waste reducer is used when a 32mm waste pipe is connected into a 50mm pipe, usually with the 32mm pipe dropping into the 50mm pipe below it running towards the soil pipe. As well as the standard lean too configuration the system can be specified as a gable roof design with the wall plates bolted back to back to form a ridge supported between two host walls or as a fee standing option supported on posts.

The three options are as follows - 32mm Solvent Weld Pipe actually measure 1 1/4 inchs or 36mm, 40mm Solvent Weld Pipe actually measure 1 1/2 inchs or 43mm, 50mm Solvent Weld pipe actually measure 2 inchs or 56mm. The system is manufactured in maintenance free powder coated aluminium in white as standard with any RAL no. Deliveries can take place from as earlier as 07:30 right up to 18:00 depending on the courier/haulier and considering local traffic etc. As this information is anonymised and aggregated it cannot be used to identify any individual user actions. To make a solvent weld joint, first ensure that the outer wall of the pipe and the inner wall of the fitting are both clean and free from grit or swarf.IMPORTANT NOTE: Solvent Weld Waste Pipe fitting sizes are often stated in metric standard measurements, however the actual pipe size is measured in imperial. The size of push fit waste fittings is based on the nominal inside bore of the pipe they are used with.

You can change your choices at any time by visiting Cookie preferences, as described in the Cookie notice.The canopy is glazed with 16mm triple wall UV stabilised polycarbonate sheeting offering greater flexibility in canopy design with enhanced strength and rigidity, available in clear, bronze or opal tints.